Automatic Chain Drive/Belt Drive Garage Door Operator System Ownerâs Manual SAVE FOR FUTURE REFERENCE Customer Service. Overhead Door Garage Door Opener Owner’s Manuals. describe the image. The Overhead Door Legacy (model #/) garage door opener. CD Series Garage Door Opener pdf manual download. Also for: Cdb Garage Door Opener Overhead door legacy Programming And Operating Manual . CAUTION Line “V” “B” Header bracket must be fastened to garage fram- ing.

Author: Dakazahn Gardagor
Country: Belarus
Language: English (Spanish)
Genre: Business
Published (Last): 5 November 2008
Pages: 329
PDF File Size: 11.55 Mb
ePub File Size: 16.6 Mb
ISBN: 505-2-52308-144-4
Downloads: 83933
Price: Free* [*Free Regsitration Required]
Uploader: Doumuro

If you plan to plug the unit into a standard electrical outlet, is one available?

Overhead Door CD Series Owner’s Manual

Please enter a valid email address. Remove all ropes and disable all locks connected legaxy thedoor before installing operator. For Phantomconnect permanent wiring to internal terminal block. Press remote control button again and the door will move the other way. Posted on Feb 26, This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.


Use wall control to run door open and close. If necessary, power headmay be mounted lower. Do Not install operator on an bb balanced door.


Draw horizontal line H across line V at this point Fig Please set aside for use later. Establish Header Bracket position Fig. Do Not connect the operator to the source of power until instructed to nanual so. Away from all moving parts of the door.

Replace power head bottom cover.

Connect white wire to terminal 2 on power head and W on manula control. You can’t post answers that contain an email address. Check to see if there are any new wireless devices, it maybe someone Cole by like a neighbor.

Radio sig- — LED goes out. Has it worked properly in the past? Not finding what you are looking for? Be sure wire ends do not touch each other or other terminals. COM1 Check your ceiling where the power head of your new unit will be mounted.

Do Not attempt to retune remote controls. STB bracket extensions are available at local dealer. If they cut into insulation, they can short wires.

  ASTM A1049 PDF

Door will only run open. If your door sticks, binds, or is out of balance, have it adjusted by a professional. Posted on Jun 27, If the door reverses when it hits the floor it is a sign that the door is traveling a bit to far.

The word NOTE is used to indicate important steps to be followed or important considerations.

Attach visor clip to remote control Fig. Model – Motor 5 Years and all other parts 3 years. Connect striped wires to terminal 2 on power head and B on wall control. Find the lift pressure screw and ajust it higher to see if that remedies the problem.

Mounting brackets can be attached to thefloor using concrete anchors not provided. If these solutions do not work, call Customer Service. Make wire attachments at power head. Ask a Question Usually answered in minutes!

Keep remote control away from children.