View Lab Report – E2_Lab_2_8_2_instructor from CSTN WAN at Georgian College. Lab Challenge Static Route Configuration (Instructor Version). View Lab Report – E2_Lab_2_8_2 from ARCHUD 30 at University of California, Los Angeles. Lab Challenge Static Route Configuration Topology. Lab Challenge Static Route. Advanced Static Routing Lab – Router Alley. Lab Configuring Static Routes Ã¢Â€Â“ Instructor Version ·
|Published (Last):||10 April 2012|
|PDF File Size:||9.41 Mb|
|ePub File Size:||13.5 Mb|
|Price:||Free* [*Free Regsitration Required]|
However, you can test connectivity between two routers and between and end device and its default gateway. Document the addresses to be used in the table provided under the Topology Diagram. Subnet this 2.8.2 to provide enough IP addresses to support 60 hosts. List the networks with slash notation. Using the next-hop IP address, configure Rroute with a summary static route that includes all of the subnets that are missing from the routing table.
Lab Challenge Static Route Configuration | Nur Hariawan Bulu
Configure a password for VTY connections. Without testing it first, do you think that PC1 can now successfully ping PC2? Mr S – Dores Community Website. If any of the above pings failed, check your physical connections and configurations.
Configure Static Routing on Aanswers. Record the command you used. Disconnect and store the cabling. Consider the following questions when creating your network design: Cable a network that is similar to the one in the Topology Diagram.
Service provider administrators are human, too, and make mistakes. However, your service provider is an active partner in solving your connectivity needs.
Static routes will also need to be configured so that hosts on networks that are not directly connected will be able to communicate with each other. You have been given the Packet Tracer Skills Integration Challenge. What networks are present in the ISP routing table? Challenge Static Route Configuration Step 2: Examine the network requirements.
HQ must be able to send any traffic for which it does not have a route to ISP. What kind of route would you need to configure on HQ to solve this problem?
Assign the last valid host address in subnet 1 to PC2. Verify Connectivity to Next-Hop Device. Document the Router Configurations On each router, capture the following command output to a text.
Lab 2.8.2: Challenge Static Route Configuration
Subnet the Address Space. Configure HQ with a default static route. Clear any existing configurations on the routers.
View the routing table of HQ to verify the new static route entries. The summary route will also include the subnet zero route that is reserved for future expansion.
View the routing table of ISP to verify configurstion new static route entry.
Scenario In this lab activity, you will be given a network address that must be subnetted to complete the addressing of the network shown in the Topology Diagram. Challenge Static Route Configuration 3.
Perform Basic Router Configurations. Configure a password for console connections.
Lab 2.8.2: Challenge Static Route Configuration – YouTube
Therefore, it is important that you understand the types of errors an ISP could make that would cause your networks to lose connectivity. How many subnets need to be created from the Assign the last valid host address in subnet 3 to PC1. Documents Flashcards Grammar checker.
You should not have connectivity between end devices yet. Clean Up Erase the configurations and reload the routers.
This document is Cisco Public Information. Configure the Ethernet interfaces. Configure ISP with a summary static route. Configure and Activate Serial and Ethernet Addresses.
Configure an EXEC mode password.