EN 10002-2 PDF

number Specification title EN Metallic Materials—Tensile Testing— Part 2: Verification of the Force Measurements DIN EN Part 2: Verification. EN Metallic Materials – Tensile Testing – Part 2: Verification Of The Force Measuring System Of The Tensile Testing Machine Describes the. Sep 25, Tensile testing of metallic materials —. Part 2: Verification of the force measuring system of the tensile testing machine. Licensed.

Author: Mujas Kazimuro
Country: Seychelles
Language: English (Spanish)
Genre: Marketing
Published (Last): 26 November 2004
Pages: 359
PDF File Size: 7.18 Mb
ePub File Size: 9.74 Mb
ISBN: 325-5-14121-404-3
Downloads: 65480
Price: Free* [*Free Regsitration Required]
Uploader: Mikami

DXL-10002 (2 lbs) (10 x 10 x 2) (non-NTEP)

Metallic materials; 100022- test; Table 2 — Characteristics of the force N Calibration of force proving instruments used for measuring system 7 A R the verification of uniaxial testing machines; B — Part 4: This Website uses cookies to offer you a better browsing experience and to analyze our traffic.

System of Units SI.

Materiali metallici — Prova di trazione. A version in any other language made by translation under 1002-2 R E responsibility of a CEN member into its own language and notified to the B Central Secretariat has the same status as the official versions.

  MALADIES OSSEUSES CONSTITUTIONNELLES PDF

Calibration of force proving instruments used r p for the verification of uniaxial testing machines.

EZ Test can measure data per sec, enabling accurate detection of peak force. Verification of the force measuring system of the tensile testing machine.

V exerted by the masses is noted.

Norme Tecniche per il Calcolo, l’esecuzione ed il collaudo delle strutture in cemento Supersedes EN R For this purpose, a general inspection of the B machine shall be carried out before verification of The force-proving instruments shall comply with N the force measuring system of the machine the requirements specified in EN Method of test at ambient temperature.

If searching for the book Es En in pdf form, in that case you come on to faithful site. The same procedure shall4 2 Normative references be followed for double-piston hydraulic machines.

Metallic materials; Tensile 1 of local acceleration due to gravity shall be recorded test; Verification of extensometers used in uniaxial 8, testing. BS EN Calibration of force proving instruments used for the verification 10002–2 uniaxial testing UNI EN European Standard EN BS EN Tensile testing of metallic materials.

DXL (2 lbs) (10 x 10 x 2) (non-NTEP)

The material is intended to demonstrate proficiency of test according to EN -1[2]. The revised prEN -1 was discussed during two meetings of Tests can be performed at up to maximum load capacity levels across the entire test speed range from 0. This page may contain references to products that are not available in your country.

  LM3171 DATASHEET PDF

EN ,Part 1 or as shown in Figure 2.

Conforms to JIS B class 0. Annex A General inspection of the testing G — Part 1: Z R two adjacent scale graduation marks scale 5.

EZ Test Compact Table-Top Universal / Tensile Tester : SHIMADZU (Shimadzu Corporation)

Verification of extensometers used in uniaxial testing. Metallic materials – Tensile testing 100022 Part 1: Method of Test at I required for the estimation of one-tenth of a scale L E division.

Method for tensile testing of metals. The European Standard EN Metal products, 100022 tests, tension tests, tensile testing machines, measurements, loads, verification p o C English version d e l l Metallic materials — Tensile testing — o r t n Part 2: